TurboCrimper® IMPACT
Get the competitive edge with a labor and cost saving TurboCrimper® Impact driver attachment. Based on actual field trials, the TurboCrimper Impact is 78% faster than using a manual sheet metal crimping tool!
This sheet metal crimping attachment is designed to work with a minimum 12 volt DC cordless or maximum 7 amp AC corded IMPACT DRIVER. No set up or adjustment is needed. Immediately begin crimping multiple sizes, types, and thicknesses of round metal duct (Including spiral duct and metal stove pipe). It also is easy to balance while using and stores comfortably in a pouch or bag when not in use.
Attention: Use Impact Driver Only! Minimum 12V DC Impact Driver With Quick Release 1/4 in. Hex Chuck. |
Check out our product spotlight for the TurboCrimper Impact, Sheet Metal Crimping Tool by clicking the link below:
Specifications
| Catalog # | Description | Impact Driver Requirements | Chuck Requirements | Net Weight oz(g) | |
|---|---|---|---|---|---|
| C5A2 | TurboCrimper IMPACT Sheet Metal Crimping Tool | Min 12V DC, Max 7A AC | 1/4 Hex, Quick Release | 30 (848) | |
| C5A2RD EV | Replacement Drive Shaft |
Capacities: Ga (mm)
| Galvanized Steel 30 – 24 Gauge | Cold Rolled Steel 30 – 24 Gauge |
| .016 – .034 (0.41 – 0.71) | .016 – .034 (0.31 – 0.61) |
Downloads
Instructions:
HOW TO USE THE CRIMPER
With the pipe or duct seam in closed position, start the crimp to one side of the seam by gently tugging on the driver trigger and angling the TurboCrimper IMPACT onto the metal edge. Walk the crimper around the pipe circumference in a controlled manner. Last, angle the crimper off the metal as the crimper approaches the other side of the seam.
Warranty:
Catalogs:
