TurboXTools™ Quarter Panel Hemming Air Tool


November 4, 2014, SEMA Show, Las Vegas, Nevada

Use air power to bend and close wheel arc flanges of replacement quarter panels. The QHT1A Air Powered Hemming TurboXTool replicates a hammer and dolly motion at high speed, with greater precision, less fatigue and faster results. Up to 80% faster based on field trials! Hemming the wheel arc of a quarter panel with this Malco TurboXTool is a smooth, controlled operation. The user can quickly hem replacement quarter panels on late model cars with a range of wheel arc flange widths up to 3/4 inch (19.05 mm). A rubber cushioned anvil protects the quarter panel from scratches and scuffs and allows the anvil and stop pegs to be aligned along the finished side of the wheel arc flange while the hammer head works from the backside. A rounded “bull nose” hammer face is used on the initial pass to quickly roll over the flange edge. A change out to the Flat Face side of the hammer head is used to close and seal the flange in one easy pass. The anvil and working hammer may be cleaned of any adhesive residue, resulting from the hemming operation, by using a common solvent. The long-wearing anvil and hammer are replaceable and easily installed on the job.

Click here to see the list of all the “SEMA Show Best New Products Named” for 2014.


  • Hem quarter panels 80% faster
  • Will not scratch or scuff panel
  • Easily and safely cleaned with solvent
  • Outstanding accessibility and power at maximum speed


Catalog #DescriptionCapacity: Mild SteelAir RequirementsSpeedTool Weight
QHT1ATurboXTools, Quarter Panel Hemming, Air Tool28-22 ga (0.38-0.76 mm)4CFM (113L/Min), 90 PSI (6.2 Bar)2600 RPM (TR/Min)3.5 lbs (1.59 kg)
QHT1RHReplacement Hammer for QHT1/QHT1A--------
QHT1RAReplacement Anvil for QHT1/QHT1A--------

My Review for TurboXTools™ Quarter Panel Hemming Air Tool

  • This field is for validation purposes and should be left unchanged.