TurboCrimper® IMPACT

Get the competitive edge with a labor and cost saving TurboCrimper® Impact driver attachment. Based on actual field trials, the TurboCrimper Impact is 78% faster than using a manual sheet metal crimping tool! The tool is designed to work with a minimum 12 volt DC cordless or maximum 7 amp AC corded IMPACT DRIVER. The crimper is equipped with a Quick Release 1/4 inch hex chuck. No set up or adjustment is needed. Immediately begin crimping multiple sizes, types, and thicknesses of round metal duct (Including spiral duct and metal stove pipe). It is also easy to balance while in use and stores comfortably in a pouch or bag when not in use.

Attention: Use Impact Driver Only! Minimum 12V DC Impact Driver With Quick Release 1/4 in. Hex Chuck.


  • The TurboCrimper Impact is 5 times faster than a manual sheet metal crimping tool.
  • Saves time and labor on your next job.
  • No setup or adjustment is needed, just chuck up and go.
  • Easily stored in a bag or pouch when not in use.


Catalog #DescriptionImpact Driver RequirementsChuck RequirementsNet Weight oz(g)
C5A2TurboCrimper IMPACTMin 12V DC, Max 7A AC1/4 Hex, Quick Release30 (848)
C5A2RD EVReplacement Drive Shaft

Capacities: Ga (mm)

Galvanized Steel 30 – 24 Gauge Cold Rolled Steel 30 – 24 Gauge
.016 – .034 (0.41 – 0.71) .016 – .034 (0.31 – 0.61)



My Review for TurboCrimper® IMPACT

  • This field is for validation purposes and should be left unchanged.