Snap Lock Punch
Snap lock plastic skirting and siding to finishing trim. Makes tabs in the cut edge of siding panel used as a finishing course at top of wall or below window. Tabs lock into utility trim.* Punch raises a high projection to compensate for natural relaxation of vinyl plastic. It also works well on aluminum siding but is not recommended for steel.
The SL5 should not be used when PERMATABS are required to snap into finished trim. For this application we reccomend using the Malco SL1R or SL2R Snap Lock Punch. PERMATABS is a trademark of C & H Enterprises. Not recommended for use below 32° F (0° C).
My Review for Snap Lock Punch
Testimonials
Tyler Barhorst
Good simple tool at decent price
This tool works as well as any other snap lock punch that I have used. It's a fairly simple tool so there is no point in spending a lot of money on one. Just as with any snap lock punch pliers, it helps if the siding is warm or has been in the sun. This cuts down on the amount of times that the "Flap" breaks off rather than just bending outward because the material is less brittle.Wendell Daar
Wonderful
Does everything it says. Makes perfect crimps. I have used it on a couple of jobs and it works great. I would recommend.Melvin Bell
Five Stars
Used it on a siding install on side of house. Works as intended.J.M.
Worked great for punching under sill for vinyl siding.
Worked great for punching under sill for vinyl siding that we were putting on. Did the job it was made for. Was sturdy.Roger
Worked really well, made the top run a breeze
Worked really well. Made the top run a breeze to snap in and lock it up tight.Peyton
This tool worked like it is supposed to
A friend, my brother in law and myself installed Vinyl Siding this past week. This tool worked like it is supposed to.Dexter
