THE MALCO QUALITY SOLUTION FOR CRIMPING BOTH LARGE AND SMALL DUCT FASTER AND EASIER BY HAVING DRILL POWER DO ALL THE WORK!

6th June 2012 • Categories: Crimpers

C5A

The Malco Turbo-X-Tools-CR Crimping Drill Attachment makes faster, easier, more precise, air-tight crimps in 24 to 30-gauge (0.71 to 0.41 mm) galvanized round duct, spiral duct, ultra-light aluminum duct and hardened (0.61 – 0.31 mm) black stove pipe.


Just insert the drive shaft of our power-assisted Crimper attachment into the chuck of your cordless drill. To get the maximum benefits from this tool, we recommend a minimum 14.4 Volt cordless or maximum 7 Amp A/C drill. The Crimpers’ telescoping clamp adjusts both in length and width to fit any drill housing. The Crimper attachment can be easily operated with one hand.

At a gear reduction of 9:1, we’ve built in both safety and control. Set the crimper lever in the down position to open the gears for easy insertion and removal of the metal in the face slot. The narrow slot will prevent fingers from entering into the gear area. When the lever is in the up position the crimping depth is set at the factory for 26 to 28-gauge (0.56 to.048mm) Galvanized Steel. For lighter metals, just back off the lever. You can change the crimp depth by adjusting the lever set screws. The clutch in the gear mechanism prevents any damage to the crimper attachment if metal thickness or layered seams ever exceed capacity.

Go to www.malcotools.com for more product details. You can check out all of Malco’s quality tools, see a video, or use the Malco Dealer Locator. Got an idea for a new tool, or a problem that could be solved with a better tool? Let us know. That’s what we do. Try to make your life easier and safer than ever before.

CLICK LINK BELOW NOW to go directly to the video demonstration of this amazing new power-assisted crimper.

MALCO CRIMPER VIDEO